-40%
DMX 512 Signal Tester and Lighting Terminator XLR 3-Pin
€ 3.73
- Description
- Size Guide
Description
You are bidding on oneDMX Signal Tester & Terminator
A
ll in One Device
Over 300 satisfied customers on this item alone
Thousands of happy customers from the 9 items I hand make.
Using a DMX Tester and Terminator will give you the ability to test if pin one or two is stuck in low voltage or high voltage it will also give you a visual of the DMX signal at the end of your signal path and after doing all of that it will still terminate the DMX signal.
Signal Tester and Terminators are Ideal for
Lighting Designers-Lighting Technicians-Bands-Churches-
Mobile DJ-Schools-
Clubs-TV studio
DMX 512 Tester Manual
The DMX 512 line tester displays the presence of the + Data and the – Data signals, when the tester is plugged into a DMX control line or feed-through connector. The LED will flicker an amber color when a DMX signal is present. If you have a solid
Red
LED then you have power but no DMX signal.
Test 1:
Plug the tester into the DMX line or feed-through connector to be tested. Once the lighting system is on, the LED should light.
If the LED is
red
, then data – (pin 2) is stuck low.
If the LED is
green
, then Data + (pin 3) is stuck low.
If the LED is not lit then common (pin 1) may be open, both lines may be stuck low or no signal is being sent.
Test 2:
With the tester plugged in, fade all the dimmers from zero to full. LED should flicker at a different rate during the fade.
If the LED is
red
and stays steady: data- (pin 3) may be stuck high.
If the LED is
green
and stays steady: data + (pin 2) may be stuck high.
If the LED is
amber
and is steady: both lines may be stuck high or the console may not be fading all dimmers.
(Lines stuck high are usually caused by a failed driver circuits in the console, splitter, isolator, etc.)
Note: Test 2 & 3 assume the DMX 512 signal is generated by a reasonably fast console. These tests may not work accurately with slow DMX 512 signals.
Features
3-Pin Neutrik NC3MX Male XLR
Metal Oxide Film Resistor which includes a
non-flammable
Coating
Each Resistor used 1/2-watt 120-Ohms with 5% Tolerance
Two color LED
Green LED data +
Red LED -
The LED will blink back and forth
green
and
red
, which will make it look
orange
Compatible with DMX512, DMX512/1990, DMX512-A, and RDM
100% quality control every piece is individually tested to DMX 512 Specifications
Hand built by myself in the
U
S
A
60-day money back warranty. Once the item is shipped back.
After 60 days I will replace with a new item for up to a year, Once the item is shipped back.